How can I fix Refilled Cartridges that don't print properly with 123.hp.com/setup?

 Refilling ink cartridges might help you save money, but they also present a special set of possible problems. If the cartridge was not correctly inserted, the printer might not print. Sometimes, when you load a cartridge, the ink doesn't drain all the way to the bottom. Any individual at home or in a small company may believe that replacing their own ink cartridges is the best solution, but the results can be less assured if done while the printhead is still connected to the cartridge. But you can visit 123.hp.com/setup to know all possible solutions for it. 

 

Smudged prints or a cartridge that isn't printing at all, which causes your printer to spit out blank pages, are the two most common problems. These problems are directly related to the cartridge's inability to be filled in a vacuum (as they are when they are done professionally). Here are a few ways to fix refilled cartridges that aren't printing properly.

Potential Problems and Approaches to Solving Refilled cartridges Issue

Your printer keeps track of used cartridges

 

You can observe the ink cartridge not recognized by 123.hp/setup because HP printers are extremely likely to recall an empty cartridge with a chip and codes inside.

 

In this case, all that is required to fix the issue is another full cartridge.

 

• Remove the empty cartridge, then refill it.

• Fill up the printer's cartridge with a new one.

• Turn on the printer and wait for it to recognise the cartridge.

• Remove the additional cartridge before printing an alignment sheet.

 

Your ink spill is Excessive

 

Another circumstance is when the new ink cartridge won't be recognized by the printer. If you have poured too much ink, this could occur.

 

Because of this, we constantly advise our clients to thoroughly read and adhere to all directions. Contact our Customer Care staff if you can't find your manual or if you have any queries, and they will assist you immediately, around the clock.

 

The cartridge is blocked or dry

The notice "HP printer ink error" can appear occasionally. The cause may be as straightforward as your cartridge being dry or blocked. Even so, adding new ink might not be able to fix the problem.

 

We'll try to summarize every solution that might be available if your HP printer refuses to recognize a fresh ink cartridge.

 

Start by doing the following steps.

 

• After 30 to 60 seconds, switch off the printer and then turn it back on to re-initialize it.

• When you hear a click, remove and reinstall the cartridge.

• The contacts on the cartridge may need to be cleaned of paint or other oxidation-related substances. To do this, take out the cartridge and use an alcohol wipe to clean the contacts.

• The contacts on the printer print head can also be cleaned and checked for integrity; this might also be a problem.

• If nothing works, your printer or cartridge must be having another issue.

 

Conclusion:

In conclusion, you must visit 123.hp.com/setup that will help you in refilling the ink cartridges if the problem continues. Instead of refilling the old cartridges, you can also replace them with new ones. Hopefully, you will understand what fixes you need to try to fix this ink cartridge issue in the HP printer.